Rv Awning Tension Spring

Reattach the rear awning leg and lower both leg sections completely.

Rv awning tension spring.

The cotter pins are the ones that lock the spring tension securely while taking down the rv awning. By meg jernigan after a few years or sooner if your awning sees heavy use your rv awning may start to look a little limp or saggy. We should test the tension before doing anything else. Adjust awning tension adjust spring tension rv awning how to adjust the tension on an rv awning awning tighting adjustments how to adjust spring tension on rv awning rv awning tension loose adjust rv awning spring rv awning spring tension.

The rotation is such that the awning winds on to the tube over the top when retracting. Posted by rv doctor. Roll the awning all the way out to full extension. Extend both awning rafter arms and lock them into place and tighten the hand screws.

I have an older carefree awning that is 182 long. Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. We are saddened to announce the passing of the rv doctor april 17 2020. Roll the awning back up to observe how tight it is.

You do not need to put the screws back in. The process is fairly simple but having someone to assist you in making the adjustments makes it easier. Note the position of the release lever 5. When you release the tension in the spring the cotter pin that is inserted in the holes in the awning arms are removed.

The spring on awnings is wound up as the awning is deployed. Now that you are going to re tension the spring it s time to insert it back after you have reinstalled the torsion assembly. Received the new spring today. The roller tube is what contains the springs and is what the awning wraps around.

The support arms are the aluminum members that extend from the awning tube to the bracket on the side of the mh 3 5 feet above the ground. When completely unwound the tube should rotate in the same direction to wind the spring as it would to roll up the awning. In the extended position it is would to it tightest. The tension arms are what you adjust to make the awning taut after it has been lowered.

Pin the opposite awning spring with a cotter pin. You can leave the support arms hanging freely but it might help to simply slide the stops back into the leg channel. In most cases readjusting the tension in the springs solves the problem. Mark the position of the ratchet end assembly with respect to the awning tube.

This helps hold everything in place.